Chapter 6 UCMs supported by Tracer Summit systems
76 BMTX-SVN01C-EN
Tracer MP503 I/O module
The Tracer MP503 input/output (I/O) module is a field-installed module
used to monitor inputs and control binary outputs. The Tracer MP503
communicates on a Comm5 communication link, It has four universal
inputs that can be configured as binary, thermistor, 0–20 mA, or 0–
10 Vdc, as well as four binary outputs.
Tracer MP580/MP581 controllers
The multi-purpose Tracer MP580 (factory-installed) and Tracer MP581
(field-installed) controllers provide control for many types of HVAC equip-
ment, including air handlers, chillers, pumps, and generic loads through
the use of generic inputs and outputs. The Tracer MP580/581 controller
requires customized Tracer Graphical Programming and configurations
using Rover service tool software Version 5.0 or higher. It communicates
on a Comm5 communication link.
The Tracer MP580/581 controller has three possible configurations: a
completely generic, programmable configuration (called a No Profile con-
figuration), a configuration conforming to the LonMark DAC profile, and
a configuration conforming to the LonMark SCC profile. The DAC and
SCC configurations enable the Tracer MP580/581 to use the appropriate
LonMark profile to send information to and receive information from the
Tracer Summit BCU, in addition to using the generic variables of the No
Profile configuration. Despite the configuration names of DAC and SCC,
Tracer Summit always treats the Tracer MP580/581 controller as a
Tracer MP580/581 object rather than as a DAC or SCC object.
Configure the control mode, either at the factory or in the field, with the
Rover service tool.
Tracer zone controllers
Tracer zone controllers monitor and control equipment such as fan coils,
classroom unit ventilators, water-source heat pumps, and blower coils.
Trane zone controllers include the following: factory-installed Tracer
ZN524, ZN510, and ZN520 and field-installed Tracer ZN511, ZN517, and
ZN521. These controllers communicate using a Comm5 communication
link.
Tracer VV550/VV551 controllers
The Tracer VV550 (factory-installed) and Tracer 551 (field-installed) con-
trollers provide digital control for variable air volume (VAV) boxes and
communicate with a Tracer Summit system using a Comm5 communica-
tions link. The controller conforms to the LonMark
Space Comfort Con-
troller (SCC) profile and interfaces to Tracer Summit through the SCC
object. System coordination of the Tracer VV550/551 controllers and their
associated air handler is accomplished with the new VAV air system
(VAS) application designed specifically for Comm5 controllers.
To Next Page
Loading...
Need help?
General
