transnorm TS 4800 - Page 17

Safety
Operating conditions
17
Operating the machine trouble-free
Implement the following measures to ensure trouble-free operation of the
machine:
 Ensure that the operating instructions are complete, in legible condition
and accessible to all personnel at all times.
 Only operate the machine when fully functional.
 Routinely check the operability of the machine and the safety equipment.
Carrying out Installation Layout
Observe the following basic safety principles when connecting several sepa-
rate components to form an overall system:
 Install isolating safety devices in areas of pulleys, apex bends, roller
arches, conveyor gates and transfer drives.
 In the vicinity of a transfer drive or a conveyor gate, the belt must have
the same speed or run faster in the outfeed area than in the infeed area.
 The national safety regulations valid in the country of use as well as
additional sector-specific requirements shall apply.
Commissioning
This conveyor system is a "partly completed" machinery, as defined by the
Machinery Directive 2006/42/EC, Article 2g. Only the use of a respective
control system and if necessary other (partly completed) machinery allows
for intralogistic functionality. It must not be commissioned until it has been
ascertained that the partly completed machinery which is the subject of this
documentation or the machinery into which it is incorporated comply with the
requirements of the Machinery Directive.