transnorm TS 4800 - Setting up the machine

Transportation and erection
Setting up the machine
36
Operating instructions: Outfeed conveyor TS 4800
Version 3.6ENG, 27.01.2020
Disposing of packaging material
The individual components of the packaging are correspondingly marked
and mainly consist of the following materials:
 Wood
 Cardboard
 PP- and PE-foil
 Styrofoam
Separate the different materials and dispose them accordingly. Observe the
local rules and regulations for disposal.
Setting up the machine
Ground requirements
The machine may only be mounted stationary on a stable concrete surface
(concrete class at least B25 or the corresponding standard in the country) or
on an equivalent steel structure. The nominal strength must be at least
25 N/mm². The installation location must be vibration-free and suitable for
the static and dynamic loads. The surface must be level.
In case special attachments are used which enable a mobile operation, this
will be stated in the service specifications.
Tolerable operating conditions
The required space for operation and maintenance depends on the indi-
vidual requirements.
DANGER
Explosion hazard!
The machine is not explosion-protected.
 Do not operate the conveyor in potentially explosive atmospheres.