transnorm TS 4800 - Remaining Risks for Technical Personnel

Safety
Remaining risks regarding the machine
24
Operating instructions: Outfeed conveyor TS 4800
Version 3.6ENG, 27.01.2020
Remaining risks for technical personnel
The following table is intended to help the technical personnel (responsible
for installation, repairs or fault elimination) to detect and avoid fundamental
dangers and hazards. Professional conduct and implementation of the corre-
sponding measures prevents remaining dangers.
It is important to observe the instructions and safety instructions during
installation works, maintenance works and repairs described in the corre-
sponding sections. This is essential for works that require to remove protec-
tive devices.
Measures for technical personnel to avert risk and prevent damage
Danger Cause Measure
Risk of fatal
injury
Accidental re-
start of the
machine
During maintenance / repair work:
 Inform your colleagues that it is prohibited to re-
start the machine until notified otherwise
 Disconnect the power supply
 Depressurise pneumatic system
 Apply a label to prevent accidental re-connec-
tion of the power supply (pneumatic system /
electrics)
 Prevent accidental re-connection of the power
supply as described in the operating instructions
of the system
Electricity For shut-down:
 Disconnect the power supply
 Secure system against accidental re-start
 Measure that the power is off
Falling or slip-
ping of loads
Transport and installation:
 Observe the centre of gravity of the machine
and the permissible lifting load of the hoists
 Secure the machine and hoists to prevent slip-
ping
 Read chapter "Transport and installation" and
carefully observe the instructions
For conveying systems ceiling suspension:
 Observe the assembly instructions of the
suspensions