Operation
Commissioning and start-up after service and maintenance works
50
Operating instructions: Outfeed conveyor TS 4800
Version 3.6ENG, 27.01.2020
Carry out electrical
installation
Danger of life due to electricity!
The machine is powered by 3-phase alternating current.
The electrical installation must be carried out by qualified and authorised
electricians.
Complete the following steps:
1. Install all required cables.
2. Attach all required plugs to cable ends.
3. Wiring of the cables and installation of required connections in compli-
ance with the manual of the motor manufacturer (see appendix, section
electrical installation).
Machine has been connected.
Check direction of
rotation
Risk of injury due to open machine parts!
Limbs, hair and clothing may be caught in rotating machine parts, causing
crush injuries.
Wear close-fitting protective clothing.
Use a hairnet in case of long hair.
Do not reach into running machine.
Do not access the machine.
Have a second person oversee the operation.
Complete the following steps:
1. Switch the machine on briefly.
2. Check for correct direction of rotation.
3. Switch off the machine.
The direction of rotation has been checked. Machine is running.
To Next Page
Loading...
