transnorm TS 4800 - Page 82

Maintenance and repair
Replacing the gear motor
82
Operating instructions: Outfeed conveyor TS 4800
Version 3.6ENG, 27.01.2020
6. Remove the gear motor (4) and place on an appropriate surface.
 Gear motor is disassembled.
 Assemble the gear
motor
Complete the following steps:
1. Assembly is carried out in the reverse order.
2. Tighten the joining elements (1) by turning clockwise.
 See the motor data sheet for tightening torque.
 Gear motor is assembled.

Gear motor is replaced.