TEW-821DAP
26
© Copyright 2015 TRENDnet. All Rights Reserved.
WDS Access Point
WDS AP is an outlet of a DS. Pairing with a WDS Staon you can build a transparent
bridge between two DS or from DS to STA.
Creang a WDS Access Point
System > Operaon Mode
1 Log into your access point management page (refer to “Log in to Management Page”
on page 10).
2 Click System > Operaon Mode.
3 On Operaon Mode secon, select WDS Access Point.
4 Click Apply to save changes or Cancel to discard the changes.
Using a WDS Bridge
Wireless 2.4GHz or Wireless 5GHz > WDS Link Sengs
1 Log into your access point management page (refer to “Log in to Management Page”
on page 10).
2 In Wireless 2.4GHz or Wireless 5GHz > Wireless Link Sengs > Remote AP MAC
Address secon, do one of the following:
• Specify the remote AP MAC address manually and click Apply or
• Click Wireless 2.4GHz or Wireless 5GHz > Wireless Link Sengs > Site Survey.
3 The available networks are listed. Select a network to connect to.
ÍNote: If you are unable to nd your wireless network in the list, click Refresh to rescan
for the available networks.
4 Click on the SSID eld to connect to the selected wireless network.
5 Click Apply to save the wireless network.
To Next Page
Loading...
Need help?
General
