TRENDnet TEW-821DAP User Manual

TRENDnet User’s Guide
TEW-821DAP
36
© Copyright 2015 TRENDnet. All Rights Reserved.
4 Enter the MAC address you wish to allow or deny depending on the Filter Mode
opon. The MAC address needs to be lled in in the hexadecimal format. For example,
00:11:22:33:44:55.

You can review the added MAC addresses in MAC Filter List table.
ÍNote: To remove the MAC address from the MAC Filter List, click Delete next to the
chosen MAC address.
5 Click Apply to save the changes or Cancel to discard the sengs.
Congure Wireless Advanced Sengs
Wireless 2.4GHz > Wireless Advanced Sengs
Fine tune your wireless sengs on this page.
1 Log into your access point management page (refer to “Log in to Management Page”
on page 10).
2 Click Wireless 2.4GHz > Wireless Advanced Sengs.
3 In Advanced Wireless secon, modify any of the following parameters:
• Data Rate: Choose a xed data rate for 802.11b and g mode and MCS number for
802.11n, or choose Auto for automac rate adapng. The default seng is Auto.

TRENDnet TEW-821DAP Specifications

General

Brand	TRENDnet
Model	TEW-821DAP
Category	Wireless Access Point
Language	English