TRENDnet TEW-821DAP - System Firmware Update; System Log Server Configuration

TRENDnet User’s Guide
TEW-821DAP
47
© Copyright 2015 TRENDnet. All Rights Reserved.
Update System Firmware
Management > Upload Firmware
TRENDnet may periodically release rmware upgrades that might add features or x
problems associated with your TRENDnet model and version. To nd out if there is a
rmware upgrade available for your device, please check your TRENDnet model and
version using the link.
hp://www.trendnet.com/downloads/
To update system rmware, do the following:
1 If a rmware upgrade is available, download the rmware to your computer.
2 Unzip the le to a folder on your computer.
3 Save the upgrade le on a ash disk.
4 Insert the ash disk into the AP.
5 Log into your access point management page (refer to “Log in to Management Page”
on page 10).
6 Click Management > Upload Firmware.
7 Click Browse to load the upgrade le from your computer.
8 Click Apply.
Congure System Log Server
Management > Log
To keep your system operang history, you can setup local and remote loggings.
To set up the remote loggings, do the following:
1 Log into your access point management page (refer to “Log in to Management Page”
on page 10).
2 Click Management > Log.
3 Check the Enable System Log checkbox.
4 Enter the log server IP address or URL.
5 Click Apply to save the sengs.
To set up the local loggins, do the following:
1 Log into your access point management page (refer to “Log in to Management Page”
on page 10).
2 Click Management > Log.
3 Select Enable to allow local logging.
You can view the log in Status > System Log.
4 Click Apply to save the sengs.