MAINTENANCE AND ADJUSTMENT
139
Coolant Level Adjustment
CAUTION
Do not remove the radiator pressure
cap when the engine is hot.
When the engine is hot, the coolant
inside the radiator will be hot and also
under pressure.
Contact with this hot, pressurised
coolant may cause minor to moderate
injury to exposed skin.
NOTICE
If hard water is used in the cooling
system, it will cause scale
accumulation in the engine and
radiator and considerably reduce the
efficiency of the cooling system.
Reduced cooling system efficiency
may cause the engine to overheat and
suffer severe damage.
To adjust the coolant level:
▼ Allow the engine to cool.
Daytona660 Only
▼ Remove the deflector fairing as
follows.
▼ Detach the top of the deflector
fairing away from the motorcycle
until it is free from the retaining
grommet (leaving the grommet in
place) and clip.
▼ Slide the deflector fairing downwards
to detach it from its retaining tang.
1. Deflector fairing
2. Retaining grommet location
3. Retaining clip location
4. Retaining tang location
To Next Page
Loading...
