GENERAL INFORMATION
90
Daytona660
Passenger Seat
NOTICE
The passenger seat must be removed
before removing the rider’s seat.
▼ Insert the ignition key into the seat
lock and turn it anticlockwise. This
will release the passenger seat from
its lock and allow it to be slid
forwards for complete removal from
the motorcycle.
Rider’s Seat
▼ Remove the passenger seat as
described above.
▼ Remove the two fixings at the rear of
the seat.
1. Rider's seat
2. Fixings
▼ Lift the seat up from the back and
slide rearwards for complete removal
from the motorcycle.
Seat - Installation
WARNING
Make sure the motorcycle is stabilised
and adequately supported.
Do not support the motorcycle on any
ancillary component, the exhaust
system or any other non structural
parts of the motorcycle frame.
A correctly supported motorcycle will
help prevent it from falling.
An unstable motorcycle may fall
resulting in motorcycle damage,
serious injury or death.
Trident
Seat
▼ Align the two locating holes at the
front of the seat with the locating
tangs on the fuel tank brackets.
▼ Engage the seat tongue with the
seat tongue locating position on the
motorcycle.
To Next Page
Loading...
