CLEANING AND STORAGE
194
Washing
To wash the motorcycle, do the
following:
▼ Make sure that the motorcycle
engine is cold.
▼ Prepare a mixture of clean, cold
water and mild automotive cleaner or
low alkaline soap.
▼ Do not use a highly alkaline soap as
commonly found at commercial car
washes because it will leave a
residue on painted surfaces and may
also cause water spotting.
▼ Wash the motorcycle with a sponge
or soft cloth.
▼ Do not use abrasive scouring pads or
steel wool. They will damage the
finish.
▼ Rinse the motorcycle thoroughly
with clean, cold water.
After Washing
WARNING
Never wax or lubricate the brake discs.
Always clean the brake disc with a
proprietary brand of oil-free brake disc
cleaner.
Waxed or lubricated brake discs may
lead to loss of motorcycle control
which could result in serious injury or
death.
After washing the motorcycle, do the
following:
▼ Remove the plastic bags and tape,
and clear the air intakes.
▼ Lubricate the pivots, bolts and nuts.
▼ Test the brakes before motorcycle
operation.
▼ Use a dry cloth or chamois leather to
absorb water residue. Do not allow
water to stand on the motorcycle as
this will lead to corrosion.
▼ Start the engine and run it for 5
minutes. Make sure that there is
adequate ventilation for the exhaust
fumes.
To Next Page
Loading...
