INSTRUMENTS
65
Trip Setup - Automatic Reset
To set the trip meter to reset
automatically:
▼ From the Trip Setup menu, press the
Up/Down button to select Trip 1
Reset or Trip 2 Reset.
▼ Press the Up/Down button to select
Automatic.
▼ Press the Right button to view the
available options.
▼ Press the Up/Down button to select
the timer setting required.
▼ Press the Select button to confirm. A
tick is shown to indicate the selected
option.
▼ The required time limit is then stored
in the trip memory.
▼ When the ignition is turned off, the
trip meter is set to zero when the
time period has elapsed.
1 Hour
2 Hours
4 Hours
12 Hours
8 Hours
The following table shows two examples
of the automatic trip reset functionality.
Ignition
Turned Off
Selected
Time Delay
Trip Meter
Resets to
Zero
10:30 hrs 4 Hours 14:30 hrs
18:00 hrs 16 Hours
10:00 hrs
(next day)
Trip 2 Display
The Trip 2 Display menu allows the Trip 2
meter to be enabled or disabled. If Trip 2
is disabled, it will no longer be shown in
the information tray.
To enable or disable the Trip 2 meter:
▼ From the Trip Setup menu, press the
Up/Down button to select Trip 2
Display.
▼ Press the Right button to view the
available options.
▼ Press the Up/Down button to select
Enabled or Disabled.
▼ Press the Select button to confirm. A
tick is shown to indicate the selected
option.
To Next Page
Loading...
