Triumph Trident 2023 - 7.1.7.2 RUN Position; 7.1.7.3 START Position; 7.1.7.4 Hazard Warning Lights Button; 7.1.8 Left Handlebar Switches

GENERAL INFORMATION
79
RUN Position
In addition to the ignition switch being
turned to the ON position, the engine
start/stop switch must be in the RUN
position for the motorcycle to operate.
START Position
The START position operates the electric
starter. For the starter to operate, the
clutch lever must be pulled to the
handlebar.
Even if the clutch lever is pulled to the
handlebar, the starter will not operate if
the side stand is down and a gear is
engaged.
Hazard Warning Lights Button
To turn the hazard warning lights on or
off, press and release the hazard
warning light button.
The ignition must be switched on for
the hazard warnings lights to be
activated, but the hazard lights will
remain active if the ignition is switched
off until the hazard warning light button
is pressed again.
Left Handlebar Switches
3
4
6
78
9
1
2
5
1. Left button
2. Up button
3. Right button
4. Down button
5. Select button
6. Direction indicator switch
7. MODE button
8. Horn button
9. High beam button
Navigation Buttons
The navigation buttons are used to
operate the following functions of the
instruments:
▼ Up - scroll the menu bottom to top
▼ Down - scroll the menu top to
bottom
▼ Left - scroll the menu to the left
▼ Right - scroll the menu to the right.