MAINTENANCE AND ADJUSTMENT
136
Engine Oil Specification and Grade
(10W/40 and 10W/50)
Triumph's high performance fuel
injected engines are designed to use
fully or semi synthetic 10W/40 or 10W/
50 motorcycle engine oil which meets
specification API SN (or higher) and JASO
MA2. Triumph Performance fully
synthetic engine oil is recommended.
NOTICE
The engine oil grade specified must be
used.
Using the incorrect engine oil grade
may result in engine damage.
Refer to the chart below for the correct
oil viscosity (10W/40 or 10W/50) to be
used in your riding area.
-20 -10 0 10 20 30 40
-4 14 5032 68 86 104
(°C)
(°F)
Ambient Temperature (°C)
Ambient Temperature (°F)
SAE 10W/50
SAE 10W/40
Oil Viscosity Temperature Range
Do not add any chemical additives to
the engine oil. The engine oil also
lubricates the clutch and any additives
could cause the clutch to slip.
Do not use mineral, vegetable, non-
detergent oil, castor based oils or any oil
not conforming to the required
specification. The use of these oils may
cause instant, severe engine damage.
Make sure that no foreign matter enters
the crankcase during an engine oil
change or top up.
To Next Page
Loading...
