INSTRUMENTS
51
WARNING
After selecting a riding mode, operate
the motorcycle in an area free from
traffic to gain familiarity with the new
settings.
Do not loan your motorcycle to
anyone as they may change the riding
mode settings from the one you are
familiar with.
Failure to follow the advice above may
lead to loss of motorcycle control
which could result in serious injury or
death.
NOTICE
The last selected riding mode will be
remembered and activated when the
ignition is switched ON.
If the riding mode icons are not shown
when the ignition switch is in the ON
position, make sure that the engine
stop switch is in the RUN position.
To select a riding mode:
▼ Press and release the Mode button
on the left hand switch housing to
activate the riding mode selection
display.
▼ The currently active riding mode icon
is shown in the information tray.
To change the selected riding mode:
▼ Press the Mode button repeatedly
until the required riding mode is
shown in the information tray. Once
in the riding mode display, the Left or
Right buttons will also scroll through
the riding mode options.
▼ Press the Select button to confirm
the selection of the required riding
mode.
▼ The selected riding mode is activated
once the following conditions for
switching riding modes have been
met:
Motorcycle Stationary - Engine Off
▼ The ignition is switched ON.
▼ The engine stop switch is in the RUN
position.
Motorcycle Stationary - Engine Running
▼ Neutral gear is selected or the clutch
is pulled in.
Motorcycle in Motion
Within 60 seconds of selecting a riding
mode the rider must carry out the
following simultaneously:
▼ Close the throttle.
▼ Make sure that the brakes are not
engaged (allow the motorcycle to
coast).
The riding mode selection is now
complete and normal riding can be
resumed.
To Next Page
Loading...
