Taking a Moisture Measurement with the
Moisture Probe
In order to use the Moisture Probe, the Moisture Input must be
set to External Sensor (default setting). See page 5–8.
1. Insert the moisture probe into the prepared hole. The
hole must be at least 7 inches deep. The probe baseplate
must contact have with the soil surface.
2. Turn on the probe. The green light illuminates. The blue
light on the probe remains solid when it has connected to
the Bluetooth in the gauge.
3. If the Moisture Input is set to External Sensor (default
setting). The gauge prompts for this measurement or the
moisture data entry:
To Next Page
Loading...
