3-5-9
Orig
CD373
Chapter 3
MZ Tow Tractor Section 5
4. Installation
(a) Install caliper assembly, fill master cylinder, and bleed brake system as described in
paragraph E of this section.
5. Check-Out
(a) Check brake pedal for sponginess or hard pedal.
(b) Drive vehicle slowly and make several slow speed stops.
(c) Check all brake fluid line fittings and caliper areas for fluid leakage.
(d) Correct any discrepancies before returning vehicle to service.
D. FRONT ROTORS
1. Rotor Removal
(a) Jack the front wheels off the ground using the procedure found in Chapter 2,
Section 1, paragraph G.
(b) Inspect the lug nuts which secure the wheel to the drive axle hub and remove.
(c) Remove the cotter pin from the hub nut and remove the nut and washer.
(d) Remove caliper assemblies. See specific section.
(e) Slide the wheel hub and rotor off the axle.
(f) Remove five bolts that secure rotor to hub.
2. Cleaning
WARNING: NO SMOKING, FIRE, OR OPEN FLAME IS PERMITTED
IN AREAS WHERE ALCOHOL IS BEING USED. AVOID INHALATION
OF FUMES.
(a) Clean rotor with alcohol or brake parts cleaner.
(b) Use lint-free cloth to dry.
To Next Page
Loading...
