EasyManua.ls Logo

TUG MZ - Brakes; Tires; Power Steering

TUG MZ
445 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1-2-7
Orig
CD373
Chapter 1
MZ Tow Tractor Section 2
2. Brakes
(a) Check master cylinder fluid level, located behind the console panel to the right of the
steering wheel. If low, top off master cylinder reservoir with DOT 3 brake fluid.
(b) Service brakes should be tested for pedal firmness and braking effectiveness.
(c) Check park brake. With the master switch in the off position, the park brake should
hold the unit in place on a 10% grade.
WARNING: DRIVE TRAIN HAS NO “PARK” POSITION AND MUST
RELY ON PARK BRAKE TO PREVENT VEHICLE FROM ROLLING.
ALWAYS MAKE SURE PARK BRAKE IS PROPERLY ADJUSTED
BEFORE PUTTING VEHICLE INTO SERVICE.
(d) Adjust park brake tension by rotating cap handle on park brake lever (clockwise to
increase tension).
3. Tires
Check tire pressure and condition.
(a) Drive (Rear) Wheels ........................................................................................ 45 psi
(b) Steer (Front) Wheels .......................................................................................... 60 psi
4. Power Steering
Check power steering fluid level. (Refer to paragraph E in Chapter 2, Section 1 for
replenishment fluid.)

Table of Contents

Related product manuals