Curtis 1234/36/38 Manual, Rev. D
33
1 1 J U LY 2 0 0 8 D R A F T
3 — PROGRAMMABLE PARAMETERS: Pump Enable Parameter (SPEED MODE)
1 – SPEED MODE PUMP ENABLE
ALLOWABLE
PARAMETER RANGE DESCRIPTION
Pump Enable On/Off This parameter should be programmed On to operate a pump motor
AC_Pump_Enable_SpdM On/Off rather than a vehicle drive motor. Speed controller responsiveness and
AC_Pump_Enable_SpdM_Bit0 [Bit 0] stability are enhanced, and the motor is allowed to turn only in the forward
direction.
To Next Page
Loading...
