Ublox SARA-R4 Series - Page 126

SARA-R4/N4 series-AT Commands Manual
UBX-17003787 - R09

13Packet switched data services
Page 126 of 307
Parameter Type Description
• 24: 3G QoS guaranteed downlink bit rate - <param_val> is the value for the
guaranteed downlink bit rate in kb/s. The factory-programmed value is 0.
• 25: 3G QoS guaranteed uplink bit rate - <param_val> is the value for the guaranteed
uplink bit rate in kb/s. The factory-programmed value is 0.
• 26: 3G QoS maximum downlink bit rate - <param_val> is the value for the maximum
downlink bit rate in kb/s. The factory-programmed value is 0.
• 27: 3G QoS maximum uplink bit rate - <param_val> is the value for the maximum
uplink bit rate in kb/s. The factory-programmed value is 0.
• 28: 3G QoS maximum SDU size - <param_val> is the value for the maximum SDU
size in octets. The factory-programmed value is 0.
• 29: 3G QoS residual bit error rate - <param_val> selects the acceptable value for the
residual bit error rate:
o 0 (factory-programmed value): subscribed
o 1: 5E2
o 2: 1E2
o 3: 5E3
o 4: 4E3
o 5: 1E3
o 6: 1E4
o 7: 1E5
o 8: 1E6
o 9: 6E8
• 30: 3G QoS SDU error ratio - <param_val> selects the acceptable value for the SDU
error ratio:
o 0 (factory-programmed value): subscribed
o 1: 1E2
o 2: 7E3
o 3: 1E3
o 4: 1E4
o 5: 1E5
o 6: 1E6
o 7: 1E1
• 31: 3G QoS signalling indicator - <param_val> selects the acceptable value for the
signalling indicator:
o 0 (factory-programmed value): subscribed
o 1: signalling indicator 1
• 32: 3G QoS source statistics descriptor - <param_val> selects the acceptable value
for the source statistics descriptor:
o 0 (factory-programmed value): subscribed
o 1: source statistics descriptor 1
• 33: 3G QoS traffic class - <param_val> selects the acceptable value for the traffic
class:
o 0 (factory-programmed value): subscribed
o 1: conversational
o 2: streaming
o 3: interactive
o 4: background
• 34: 3G QoS traffic priority - <param_val> selects the acceptable value for the traffic
priority:
o 0 (factory-programmed value): subscribed
o 1: priority 1
o 2: priority 2
o 3: priority 3
• 35: 3G QoS transfer delay - <param_val> is the value for the transfer delay in
milliseconds. The factory-programmed value is 0.
• 36: 3G minimum QoS delivery order - <param_val> selects the acceptable value for
the delivery order:
o 0 (factory-programmed value): subscribed
o 1: enable