EasyManuals Logo

Uniden BCD436HP User Manual

Uniden BCD436HP
112 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
18
Using Internal Batteries (BCD436HP Only)
You can power your scanner using three alkaline or rechargeable AA batteries.
There is no switch. The scanner will automatically detect and not charge non-
rechargeable batteries.
1. Install 3 AA batteries, matching the polarity symbols (+ -).
2. Replace the cover.
When Battery icon flashes and the scanner beeps every 15 seconds, replace or
recharge the batteries.
Using Rechargeable Batteries
You can also use three rechargeable batteries to power your scanner. Before you
use rechargeable batteries, you must charge them. The scanner has a built-in
circuit that lets you recharge batteries while they are in the scanner.
If the USB cable is connected to the scanner, or batteries are installed in the
scanner when an USB cable is connected, the scanner will check the battery
condition.
When the scanner is turned on, the scanner does not charge the battery.
When the scanner is turned off, the scanner will charge the battery.
The scanner displays “Normal Charging while charging the battery according to
the Set Charge Time setting.
If the batteries are not installed, “No Battery is displayed.

Table of Contents

Other manuals for Uniden BCD436HP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Uniden BCD436HP and is the answer not in the manual?

Uniden BCD436HP Specifications

General IconGeneral
ModelBCD436HP
AntennaRemovable SMA Antenna
Close Call RF CaptureYes
Dynamic MemoryYes
PC ProgrammableYes
Water ResistanceNo
CategoryScanner Radio
DisplayDot-matrix LCD
Power Source3x AA batteries or USB power
Weight10.1 oz
TypeHandheld
GPSOptional GPS receiver supported
Audio OutputEarphone jack (3.5 mm)
Trunking Systems SupportedMotorola, EDACS, LTR, APCO 25 Phase I and Phase II
Modulation TypesAM, FM, NFM, P25
Battery LifeVaries with usage
Display TypeLCD
USB PortYes
SD Card SlotYes
Frequency Range25-512 MHz, 758-960 MHz, 1240-1300 MHz

Related product manuals