Startup Keys
You can program each of your Favorites Lists with a Startup Key (0-9) so that
when you power up the scanner and press the key number, just those Favorites
List(s) assigned to the key will be enabled for scan. Systems are not affected.
Number Tags
Numbers tags will allow you to tag each Favorites List, System, and Channel to
locate easier. Number tags can range from 0 to 99 for Favorites Lists and
Systems and 0-999 for Channels. You can assign number tags to channels even
if the Favorites List does not have a number tag but, without a Favorites List
number tag, you can only navigate to these channels while holding or scanning in
that Favorites List. If two Favorites Lists have the same number tag, they will be
selected in sequence. The first time you select the number tag, the scanner will
go to the first Favorites List assigned to that number tag; if you select the same
number tag again, it will go to the 2nd Favorites List assigned to that number tag,
and so on. The same rule applies to System and Channel number tags. See also
Using Number Tags.
Alerts
You can program your scanner to alert you when, a Channel or Unit ID is
received, you receive a Close Call hit, an ID is transmitted with an Emergency
Alert or you receive a Tone-out hit. For each alert in the scanner, you can select
from 9 different tone patterns, 15 volume settings, 7 colors, and 2 color patterns.
Favorites Lists hold all your Systems, Sites, Departments, and Channels. You
should assign a Quick Key to every Favorites List to quickly enable or disable the
list. You can assign as many Favorites Lists you want to a Favorites List quick
key.
To Next Page
Loading...
Need help?
General
