31
Press Func then 7(IFX) to toggle intermediate frequency exchange
for a channel/frequency in Hold Modes.
Press Func then press and hold 8(REV) to view the repeater
frequency in Hold Modes.
Press Func then 9(DISP) to toggle 3 line display on/off
in Scan Hold Mode.
Press Func then 0(LVL) to toggle the volume offset for a channel
in Scan Hold Mode.
Press to enter a decimal point for a frequency.
Press to enter a decimal point after a system number tag.
Press to delete current character with Data Naming/Direct Entry.
Press twice to delete all characters with Data Naming/Direct Entry.
Press twice to enter a hyphen when entering an ID.
Press to enter an 'i' when entering an I-Call ID.
Press Func then .no to toggle Priority Modes.
Press to select a menu item or save an entry in Menu Mode.
Press to store a blinking CTCSS/DCS/NAC tone in Scan Mode.
Press to store an ID in ID Search mode in Scan Mode.
Press for Channel Menu in Hold/Receive Mode.
Press to 'quick store' a frequency in Search Modes.
Press Func then E/yes to start Quick Search in Search Mode.
Press to store found tones in Tone-out Search Mode.
Press to for the current Tone-Out menu in Tone-out Mode.
The Menu key lets you select options to set up and use the scanner. To select a
menu item, rotate the scroll control. Rotate right for down and left for up. The
currently-selected menu item is highlighted with a bar in the display. When the
menu item you want to select is highlighted, press E(yes) or (the scroll control)
to select it. To back up a level, press Menu. To exit all menus and return to the
previous mode press Avoid.
The message “Press Any Key” in Menu Mode means press any key except the
Avoid key.
To Next Page
Loading...
Need help?
General
