Uniden BCD436HP User Manual

82
Using Close Call
Close Call Only Mode
(BCD536HP) Press and hold SQ( ).
(BCD436HP) Press Channel to hold on any channel/frequency.
Press Func then press and hold Avoid/ . See also Set Search Key.
When the scanner detects a Close Call signal, CC Found! and Press Any Key
appear for the length of time set in Close Call Pause.
The band number will blink under the band that the hit was found in.
Close Call Only Mode
Toggle Close Call Bands
Press the number keys to enable or disable each Close Call band.
Cancel a Hit
Turn the Scroll Control.
Holding on a Hit
Press Channel to hold on the Close Call Hit. Press Channel to cancel hold.
View Last Hit
Press Channel to recall the last hit.
Avoiding Hits Temporary Avoids cancel when you cycle power.
Press Avoid once to Temporary Avoid.
Press quickly to toggle Permanent Avoid and Stop Avoiding when the
frequency is in the display or in Search Hold mode.
Review Avoids - Press Channel to hold on any Frequency.
Press Func then Avoid. Scroll to each frequency and press E/yes to Stop
Avoiding. Temporary Avoids appear reversed in the display- .
Clear All Avoids - Press Channel to hold on any Frequency.
Press and hold Avoid. At Confirm Delete? Press E/yes or .no.

Uniden BCD436HP Specifications

General

Model	BCD436HP
Antenna	Removable SMA Antenna
Close Call RF Capture	Yes
Dynamic Memory	Yes
PC Programmable	Yes
Water Resistance	No
Category	Scanner Radio
Display	Dot-matrix LCD
Power Source	3x AA batteries or USB power
Weight	10.1 oz
Type	Handheld
GPS	Optional GPS receiver supported
Audio Output	Earphone jack (3.5 mm)
Trunking Systems Supported	Motorola, EDACS, LTR, APCO 25 Phase I and Phase II
Modulation Types	AM, FM, NFM, P25
Battery Life	Varies with usage
Display Type	LCD
USB Port	Yes
SD Card Slot	Yes
Frequency Range	25-512 MHz, 758-960 MHz, 1240-1300 MHz