84
Set Delay Time Sets the number of seconds the scanner should wait after a
transmission stops before moving on to the next channel during weather scan.
A negative delay will force a resume after that number of seconds.
The default setting is 2 seconds.
-10, -5, -2, 0, 1, 2, 5, 10, or 30 sec.
Set Attenuator Sets the attenuator (20 dB) for weather operation.
The default setting is Off.
Note: You can also toggle attenuation for weather scan by pressing Func
then 4(ATT).
Set Audio AGC This allows you to turn AGC (Automatic Gain Control) on or
off for Weather operations. The default setting is Off.
Analog - Press E/yes to toggle On or Off.
Program SAME SAME (Specific Area Messaging System) is a system
developed by the National Weather Service to reduce the number of alerts
received by consumers by allowing them to hear alerts only for the county(ies)
they are interested in. Each alert contains information about the type and severity
of the alert, as well as the specific geographic locations affected by the alert.
To receive SAME alerts, you can program up to 5 groups of 8 FIPS codes (40
codes) into the scanners memory.
To find the FIPS codes for your scanner call the NWS toll free at 1-888-697-7263
(follow the instructions you hear) or see FIP codes for the United States and its
Possessions.
SAME 1-5 Select for each SAME group.
Edit Name See Data Naming.
Code 1-8 Select for each FIP code.
Enter the FIPS code and press E/yes to save.
-10, -5, -2, 0, 1, 2, 5, 10, or 30 sec.
To Next Page
Loading...
Need help?
General
