Uniden BCD436HP User Manual

85
Weather Options
Weather Alert Priority Turning the weather alert priority feature on allows
the scanner to check the weather channels every 5 seconds for a 1050 Hz
weather alert signal and still scan or search. If you should receive an alert, you
will hear a loud warbling then the weather channel audio.
On or Off
Note: You can also toggle weather alert priority in scan or search modes by
holding on any channel and pressing Func then 6(wx).
Weather Scan
Press Channel to hold on any channel/frequency. Press and hold 6(WX).
The scanner starts scanning the preprogrammed weather frequencies and stops
on the first good signal. If the signal is lost, the scanner resumes searching for
another weather transmission.
Change Channel
Turn the Scroll Control.
Attenuation Press Func then 4(ATT).
Modulation Press Func then Channel(MOD).
Intermediate Frequency Exchange - Press Channel to hold on any
frequency. Press Func then 7(IFX) to toggle on or off.
Replay the Last Transmissions Press Replay.
Press Channel to pause/resume replay.
Turn the Scroll Control to select recordings.
Start/Stop Recording Press Func then Replay.
Weather Menu - Press Func then Menu.

Uniden BCD436HP Specifications

General

Model	BCD436HP
Antenna	Removable SMA Antenna
Close Call RF Capture	Yes
Dynamic Memory	Yes
PC Programmable	Yes
Water Resistance	No
Category	Scanner Radio
Display	Dot-matrix LCD
Power Source	3x AA batteries or USB power
Weight	10.1 oz
Type	Handheld
GPS	Optional GPS receiver supported
Audio Output	Earphone jack (3.5 mm)
Trunking Systems Supported	Motorola, EDACS, LTR, APCO 25 Phase I and Phase II
Modulation Types	AM, FM, NFM, P25
Battery Life	Varies with usage
Display Type	LCD
USB Port	Yes
SD Card Slot	Yes
Frequency Range	25-512 MHz, 758-960 MHz, 1240-1300 MHz