EasyManuals Logo

Uniden BCD436HP User Manual

Uniden BCD436HP
112 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
1
Important Information
The FCC Wants You to Know
IMPORTANT! This scanning radio has been manufactured so that it will not
tune to the radio frequencies assigned by the FCC for cellular telephone usage.
The Electronic Communications Privacy Act of 1986, as amended, makes it a
federal crime to intentionally intercept cellular or cordless telephone
transmissions or to market this radio when altered to receive them. The
installation, possession, or use of this scanning radio in a motor vehicle may be
prohibited, regulated, or require a permit in certain states, cities, and/or local
jurisdictions. Your local law enforcement officials should be able to provide you
with information regarding the laws in your community.
Modification Notice
Changes or modifications to this product not expressly approved by Uniden, or
operation of this product in any way other than as detailed by this Users Guide,
could void your authority to operate this product.
Part 15 Information
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.

Table of Contents

Other manuals for Uniden BCD436HP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Uniden BCD436HP and is the answer not in the manual?

Uniden BCD436HP Specifications

General IconGeneral
ModelBCD436HP
AntennaRemovable SMA Antenna
Close Call RF CaptureYes
Dynamic MemoryYes
PC ProgrammableYes
Water ResistanceNo
CategoryScanner Radio
DisplayDot-matrix LCD
Power Source3x AA batteries or USB power
Weight10.1 oz
TypeHandheld
GPSOptional GPS receiver supported
Audio OutputEarphone jack (3.5 mm)
Trunking Systems SupportedMotorola, EDACS, LTR, APCO 25 Phase I and Phase II
Modulation TypesAM, FM, NFM, P25
Battery LifeVaries with usage
Display TypeLCD
USB PortYes
SD Card SlotYes
Frequency Range25-512 MHz, 758-960 MHz, 1240-1300 MHz

Related product manuals