Uniden BCD436HP User Manual

77
Search Options
Set Search Key The scanner has three search keys that you can assign to a
search range. The search keys are number keys 1, 2, and 3. This allows you to
start a Custom, Tone-Out, or Close Call Search without having to go into the
menus.
Search Key 1-3 Select for each Search Key.
Custom Search 1-10, Tone-Out, or Close Call.
Search with Scan This enables Custom Searches in Scan Mode.
See also Select Lists to Monitor and Edit Custom Search.
Set System Avoid
Temporary Avoid, Stop Avoiding, or Avoid.
Searching
Quick Search
Allows you to enter a frequency and start searching.
Quick Search will search all the way up to 1300 MHz or all the way down to 25
MHz then start over.
Press Channel to hold on any channel or frequency. Enter the new frequency
you wish to start at then press Channel to set the new starting frequency. Press
Channel again to release hold mode and start searching.

Uniden BCD436HP Specifications

General

Model	BCD436HP
Antenna	Removable SMA Antenna
Close Call RF Capture	Yes
Dynamic Memory	Yes
PC Programmable	Yes
Water Resistance	No
Category	Scanner Radio
Display	Dot-matrix LCD
Power Source	3x AA batteries or USB power
Weight	10.1 oz
Type	Handheld
GPS	Optional GPS receiver supported
Audio Output	Earphone jack (3.5 mm)
Trunking Systems Supported	Motorola, EDACS, LTR, APCO 25 Phase I and Phase II
Modulation Types	AM, FM, NFM, P25
Battery Life	Varies with usage
Display Type	LCD
USB Port	Yes
SD Card Slot	Yes
Frequency Range	25-512 MHz, 758-960 MHz, 1240-1300 MHz