EasyManuals Logo

Uniden BCD436HP User Manual

Uniden BCD436HP
112 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #49 background imageLoading...
Page #49 background image
43
Managing Favorites Lists
Rename This allows to you rename the Favorites List.
See Data Naming.
Delete This will delete the Favorites List.
At Confirm Delete? Press E/yes or .no.
Information This will show you the file size and number of Systems in the list.
Understanding Location Control
Location Control allows you to enable or disable channels scanned in a Favorites
List based on your location. Actually, it enables/disables Sites and Departments
in Favorites Lists (as long as they have locations programmed) based on your
current location and scan range settings. Location Control is always enabled
when scanning from the Full Database.
To use Location Control, you have to enable it for each Favorites List (default is
No). You also need to have locations programmed for Sites and Departments in
each list (you can’t program a location for a system). With Location Control set to
Yes, the scanner only sees Departments/Sites with programmed locations. Any
Department/Site with no location information programmed will not be scanned. If
you append (add) a System/Department to a list from the database, the locations
will be brought in with each System/Department you append. With Location
Control set to No, the scanner will enable all Sites and Departments in your
Favorites List no matter what the scan range or Site/Department range is set to.
You don’t need a GPS to scan by location if all of the following apply:
1. You have Location Control set to Yes for each Favorites List you want to use
with Location Control.
2. You set (by zip/post code, Auto Locate, or manually), or select a location.
3. Your Departments and Sites have locations programmed.
The scanner then compares your location data with Site and Department data to
determine which channels to scan.
Conceivably, you could program everything you want to hear into one Favorites
List and scan just by selecting locations rather than enabling/disabling lists. If you
are traveling long distances a GPS device would be a better way to go.

Table of Contents

Other manuals for Uniden BCD436HP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Uniden BCD436HP and is the answer not in the manual?

Uniden BCD436HP Specifications

General IconGeneral
ModelBCD436HP
AntennaRemovable SMA Antenna
Close Call RF CaptureYes
Dynamic MemoryYes
PC ProgrammableYes
Water ResistanceNo
CategoryScanner Radio
DisplayDot-matrix LCD
Power Source3x AA batteries or USB power
Weight10.1 oz
TypeHandheld
GPSOptional GPS receiver supported
Audio OutputEarphone jack (3.5 mm)
Trunking Systems SupportedMotorola, EDACS, LTR, APCO 25 Phase I and Phase II
Modulation TypesAM, FM, NFM, P25
Battery LifeVaries with usage
Display TypeLCD
USB PortYes
SD Card SlotYes
Frequency Range25-512 MHz, 758-960 MHz, 1240-1300 MHz

Related product manuals