60
The highest priority is for channels in Favorites List Quick Key 1 and System
Quick Key 1. The lowest priority is for channels in Favorites List Quick Key 90
and System Quick Key 90. Priority for priority channels in the same channel
Department follows the order in which the channels were created.
To use Priority Scan you must first set your Priority Channels.
To use Priority ID Scan you must also enable Priority ID Scan for each system.
To Toggle Priority Modes Press Func then .no.
Priority Scan Options
Press Menu then scroll to Priority Scan and press E/yes.
Set Priority Sets the Priority Mode. You can also toggle these modes by
holding on any channel in scan mode and pressing Func then .no(Pri).
Off - The Priority feature is off.
Priority DND - The scanner checks Priority channels only when not receiving
other conventional channels.
PRI appears in the display reversed- .
Priority Scan - The scanner checks conventional priority channels, and priority
IDs within systems that have priority ID enabled.
PRI appears in the display- .
Set Interval This sets (in seconds) how often the scanner will check the priority
channels.
MaxChannels/Pri-Scan This sets the maximum number of priority channels
that are scanned during one priority scan interrupt. If there are more priority
channels than the value you select, the channels are divided into more than one
group and the scanner scans each group in turn. Example: If you set the
maximum channels to 20 and there are 100 priority channels, the scanner checks
those 100 channels in groups of 20 and takes a total of 5 intervals to complete
the priority scan.
To Next Page
Loading...
Need help?
General
