46
Set Hold Time This sets (in seconds) the amount of time the scanner will scan
the System before moving on to the next system. All (Unavoided) channels will be
scanned at least once regardless of this setting. The scanner moves to the next
system after the hold time expires, any current transmission ends, and the
channel delay time expires. The default setting is 2 seconds.
Tip: Set your systems to 0 for fastest overall scan speed.
ID Search This sets whether the scanner searches for all IDs in a trunking
system (On), or scans only programmed IDs (Off).
The default setting is Off. See also ID Scan/Search.
Edit Fleet Map (Motorola Type I/lli systems Only) This allows you to
program a fleet map for Motorola Type I Systems. You must program a system
fleet map in order for the scanner to properly track and display talk group IDs.
Block 0 Scroll to the size code (0-14) and press E/yes.
The next available block is prompted to select the next size code (0-14).
Repeat for each block as needed (0-7).
Note: If you select size code 12, 13, or 14, these restrictions apply:
12 can only be assigned to Blocks 0, 2, 4 or 6.
13 can only be assigned to Blocks 0 and 4.
14 can only be assigned to Block 0.
Since these size codes require multiple blocks, you will be prompted for the
next available block. Example: If you assign Block 0 as 12, the scanner
prompts you for block 2, the next block available, instead of block 1.
Priority ID Scan (no P25-1Tr) This allows you to use Priority Scan with IDs in
the System. The default setting is Off.
Set Status Bit (Motorola Only) This sets how your scanner works with Status
Bits (also called S-bits), letting you control how the scanner interprets and
displays Motorola talk group IDs. The default setting is Ignore.
Yes - the scanner treats all received IDs as unique IDs.
Ignore - the scanner rounds all received IDs down to the next interval of 16.
Set End Code (Motorola Only) This sets how the scanner handles the
transmission end code sent by most Motorola Systems.
The default setting is Ignore.
Analog - The scanner recognizes only analog end transmission codes.
Analog+Digital - The scanner recognizes both analog and digital end codes.
Ignore - The scanner waits for the carrier to drop before leaving a channel.
To Next Page
Loading...
Need help?
General
