Uniden BCD436HP User Manual

71
Session Options
Press Menu then scroll to Discovery and press E/yes.
Scroll to Trunking/Conventional Discovery and press E/yes.
Scroll to the Discovery Session and press E/yes.
Start Discovery
Set Compare to Database
Edit Session Name
Set Record Duration
Set Limit Frequencies
Set Time-Out Timer
Set Modulation
System Info
Set Step
Set Auto Store
Set Delay
Delete Session
Set Logging
Change System
Start Discovery This starts the Discovery Session.
Press Menu to stop and review the Run information. See Review Discovery.
Press Avoid to Avoid a hit.
Press Func then System to exit.
Edit Session Name This allows you to name a Session.
See Data Naming.
Set Limit Frequencies (Conventional Only)
This sets the lower and upper frequencies for conventional discovery session.
Set Lower Limit Enter the lower limit.
Set Upper Limit Enter the upper limit.
Set Modulation (Conventional Only) This sets the modulation for
conventional discovery session.
Auto, AM, FM, NFM, WFM, or FMB (FM Broadcast)
Set Step (Conventional Only) This sets the step size for conventional
discovery session.
Auto, 5, 6.25, 7.5, 8.33, 10, 12.5, 15, 20, 25, 50, or 100 kHz.
Set Delay This sets the Delay when monitoring a site or frequencies.
0, 1, 2, 3, 4, or 5 sec.
Set Logging This will log all hits or just new hits.
All or New Only

Uniden BCD436HP Specifications

General

Model	BCD436HP
Antenna	Removable SMA Antenna
Close Call RF Capture	Yes
Dynamic Memory	Yes
PC Programmable	Yes
Water Resistance	No
Category	Scanner Radio
Display	Dot-matrix LCD
Power Source	3x AA batteries or USB power
Weight	10.1 oz
Type	Handheld
GPS	Optional GPS receiver supported
Audio Output	Earphone jack (3.5 mm)
Trunking Systems Supported	Motorola, EDACS, LTR, APCO 25 Phase I and Phase II
Modulation Types	AM, FM, NFM, P25
Battery Life	Varies with usage
Display Type	LCD
USB Port	Yes
SD Card Slot	Yes
Frequency Range	25-512 MHz, 758-960 MHz, 1240-1300 MHz