Unify OpenScape CP205

94 Other settings and functions
Announcement (broadcast) to all members of a line
trunk group
You can use this function to send an announcement to all members (10 to 40) of
a line trunk group.
Z Once you have activated the group call, you will hear a confirmation tone. You
can then begin the announcement.
^ Lift the handset.
or
: Press the key shown for speakerphone mode.
j Enter the system code for "Speaker call-1-way bcst" (consult your administrator
if necessary).
or
Press the programmed "Broadcst Spk" key.
j Enter the internal phone number of a group member.
Z The loudspeakers on all group phones are automatically switched on and you
will hear a confirmation tone. You can begin the announcement.
\ You end the announcement by replacing the handset.
^ If a group member lifts their handset, they are connected to you and the an-
nouncement is ended.
: If a group member presses the speaker key
or
the relevant line key for the announcement, they are disconnected from the an-
nouncement. If the last remaining member of the group presses the speaker key
or line key, the announcement ends.
Broadcst Spk
_
DSS
_