Unipulse F381A - Page 58

49
4 SETTINGS AND CALIBRATIONS
49
SETTINGS AND CALIBRATIONS
Chapter
4
① Only Forced-Stop
Setting of “4. Measurement Stop Level” is disabled.
- 2048 points
Measurement stops when the number of points of
measurement data exceeds 2048.
- External input
Measurement stops when the external input signal
“Stop” turns OFF → ON.
②Load
Measurement stops when the forced-stop or the load
crosses the Measurement Stop Level.
③Time
Measurement stops when the forced-stop or the time
specified under Measurement Stop Level has passed
after measurement start.
Load
Time or displacement
2048 points
Measurement
Section
Load
Time or
Stop
OFF
ON
Measurement
Section
displacement
Load
Time or displacement
Stop
load
Measurement
Section
Stop level
Load
Stop point Stop point
×
Not crossing
×
Not crossing
〇
Crossing in the
negative-to-
〇
Crossing in the
positive-to-
negative directionpositive direction
Load
Time
Time
or
displacement
Measurement
Section