18.3 Program structure functionality
18.3.6 Core Pullers In
Enables the movement of the core pullers to position 1. Which core pullers are used is selected from
the drop down menu. Use the checkboxes to enable/disable individual steps.
18.3.7 Core Pullers Out
Enables the movement of the core pullers to position 2. Which core pullers are used is selected from
the drop down menu. Use the checkboxes to enable/disable individual steps.
CB3 III-20 Version 3.10
Copyright © 2009–2019 by Universal Robots A/S. All rights reserved.
To Next Page
Loading...
