2DA/2DB-1
1-4-3
Section
Item
Maintenance item contents
Initial
No. setting*
U100 Checking the operation of main high voltage 132/60/50/10
U101 Setting high voltages
• Developing bias 27/45/22/45
•Transfer voltage 166/177/37/35
• Separation voltage 1/35/42
U110 Checking/clearing the drum count —
U130 Initial setting for the developer —
U144 Setting toner loading operation OFF
U157 Checking/clearing the developing drive time —
U158 Checking the developing count —
U161 Setting the fixing control temperature
• Primary stabilization fixing temperature 140
• Secondary stabilization fixing temperature 160
• Copying operation temperature 1 170
• Copying operation temperature 2 180
• Number of sheets for fixing control 5
• Number of sheets for fixing control (thick paper) 20
U162 Stabilizing fixing forcibly —
U163 Resetting the fixing problem data —
U167 Checking/clearing fixing counts —
U199 Checking the fixing temperature —
U200 Turning all LEDs on —
U202 Setting the KMAS host monitoring system —
U203 Checking DP operation —
U204 Setting the presence or absence of a key card or key counter —
U207 Checking the operation panel keys —
U243 Checking the operation of the DP motors and solenoids —
U244 Checking the DP switches —
U245 Checking messages —
U246 Setting the finisher 4/4/4
U249 Checking the paper ejection to optional devices —
U250 Setting the maintenance cycle 150000
U251 Checking/clearing the maintenance count —
U252 Setting the destination Japan
U253 Switching between double and single counts Double count
U254 Turning auto start function on/off On
U258 Switching copy operation at toner empty detection Single mode
U260 Changing the copy count timing After ejection
U264 Setting the display order of the date Inch
specifications:
MONTH-DATE-YEAR
Metric
specifications:
DATE-MONTH-YEAR
U265 Setting OEM purchaser code —
U277 Setting auto application change time 30
U326 Setting the black line cleaning indication ON
U332 Setting the size conversion factor —
U341 Specific paper feed location setting for printing function —
U342 Setting the ejection restriction On
U343 Switching between duplex/simplex copy mode Off
* Initial setting for executing maintenance item U020
High voltage
Developing
Fixing and
cleaning
Operation
panel and
support
equipment
Mode setting
To Next Page
