UTC Fire and Security FenwalNET 8000-ML - Page 126

Configuration and Programming
February 2011 3-26 P/N 06-237041-001
Figure 3-24. FenwalNET 8000-ML Set Menu Functions (Cont’d - Fig. 8 of 14)
3. SET
4. Programming
3. AutoLearn
Cont’d
*
5. ALM VERIFICATION
6. POSITIVE ALM SEQ
7. Clear Events
8. Clear Tests
9. Resynch Network
Clearing SLC Test Results
SLC Devices From*__ to __
 (1-255)
1. Clear SLC Tests * 
Assign Alarm Verification
1: Enable 2: Disable
Assign Positive Alarm Sequence
1: Enable 2: Disable
Event Log Clear
1: Clear Events 2: Exit *

2. Clear Walk Tests * 
Clearing Walk Test Results
SLC Devices From*__ to __
 (1-255)
*= Level-2 (Installer) Password required .
26
28
29
30
31
32
33
SLC Module Selection
Enter SLC Module Number (1-8):_*
SLC Module Selection
Enter SLC Module Number (1-8):_*
SLC Module Selection
Enter SLC Module Number (1-8):_*
SLC Module Selection
Enter SLC Module Number (1-8):_*
AutoLearning Devices on SLC
Registered .X Devices on SLC
4. AutoSetup
27
AutoSetup will Overwrite EOC, Proceed?
1: Continue 2: Cancel _*