Parameters vacon • 120
Service support: find your nearest Vacon service center at www.vacon.com
6
P3.1.4.12.2 I/F START FREQ
I/f start function is used when the drive’s output frequency is below this frequency limit. When
the output frequency exceeds this limit, the drive operation mode is changed back to normal
U/f control mode.
P3.1.4.12.3 I/
F START CURRENT
This parameter defines the current to be fed to the motor when the I/f start function is activat-
ed.
6.2.3 Start/Stop Setup
P3.2.5 S
TOP FUNCTION
Table 113.
Selection
number
Selection name Description
0 Coasting The motor is allowed to stop on its own inertia. The control by the
drive is discontinued and the drive current drops to zero as soon as
the stop command is given.
1Ramp to min
frequency
After the Stop command, the speed of the motor is decelerated to
minimum frequency according to the set deceleration parameters .
2Ramp to zero
frequency
After the Stop command, the speed of the motor is decelerated to
zero frequency according to the set deceleration parameters .
To Next Page
Loading...
