Vacon 100X series - 6.1 Application parameter lists

Parameters vacon • 66
Service support: find your nearest Vacon service center at www.vacon.com
6
6. PARAMETERS
The Vacon AC drive contains a preloaded Vacon 100X Solar Pump application for instant use.
The parameters of this application are listed in this chapter.
6.1 Application parameter lists
Find the parameter menu and the parameter groups as guided below.
The Vacon 100 X Solar Pump Application embodies the following parameter groups:
Table 44. Parameter groups
Menu and Parameter group Description
Group 3.1: Motor settings Basic and advanced motor settings
Group 3.2: Start/Stop setup Start and stop functions
Group 3.3: References Parameters for setting references and preset speeds.
Group 3.4: Ramps And Brakes Acceleration/Deceleration setup
Group 3.5: I/O Config I/O programming
Group 3.6: Fieldbus DataMap Process data in/out mapping
Group 3.7: Prohibit Freq Prohibit frequencies programming
Group 3.8: Supervisions Programmable limit controllers
Group 3.9: Protections Protections configuration
Group 3.10: Automatic reset Auto reset after fault configuration
Group 3.11: Appl. Settings Application settings
Group 3.12: Timer functions Configuration of 3 timers based on Real Time Clock.
Group 3.13: PID Controller Parameters for PID Controller 1.
Group 3.14: ExtPID Controller Parameters for external PID Controller.
Group 3.16: Mainten. Counters Parameters related to Maintenance counters.
Group 3.21: Pump Control Pump function parameters
Group 3.22: Solar Solar specific function parameters
Main Menu

Quick Setup
( 17 )

( 6 )
Monitor

ID: M3
STOP READY Keypad
Parameters
( 13 )

STOP READY Keypad




Motor Settings
( 2 )
Start/Stop Setup
( 7 )
References
( 18 )
Parameters
ID: M3.1
OK
9147.emf
OK
9151.emf