Vacon 100X series - Vacon Graphical Keypad

User Interfaces vacon • 24
Service support: find your nearest Vacon service center at www.vacon.com
4
4.1.4 Vacon graphical keypad
Figure 2. Main menu
4.1.4.1
Using the graphical keypad
Editing values
The selectable values can be accessed and edited in two different ways on the graphical key-
pad.
Parameters with one valid value
Typically, one parameter is set one value. The value is selected either from a list of values (see
example below) or the parameter is given a numerical value from a defined range (e.g.
0.00...50.00 Hz).
Change value of a parameter following the procedure below:
1. Locate the parameter.
2. Enter the
Edit mode.
3. Set new value with the arrow buttons up/down. You can also move from digit to digit with
the arrow buttons left/right if the value is numerical and then change the value with the
arrow buttons up/down.
4. Confirm change with OK button or ignore change by returning to previous level with Back/
Reset button.
9159.emf
Main Menu
Quick Setup
( 17 )
Parameters
( 12 )

STOP READY I/O
ID: M1
( 5 )
Monitor

Status field
STOP/RUN
Direction
ALARM
Status field
READY/NOT READY/FAULT
Control place:
PC/IO/KEYPAD/FIELDBUS
Activated group/item:
Press OK to enter
Number of items
in the group
Location field
(Parameter ID number and
current menu location