Vacon 100X series - Page 28

4
vacon • 25 User Interfaces
Figure 3. Typical editing of values on graphical keypad (text value)
Figure 4. Typical editing of values on graphical keypad (numerical value)
Parameters with checkbox selection
Some parameters allow selecting several values. Make a checkbox selection at each value you
wish to activate as instructed below.
Figure 5. Applying the checkbox value selection on graphical keypad

Start/Stop Setup
Rem Control Place
I/O Control
KeypadStopButton
Yes
Start Function
Ramping
STOP READY I/O
ID:172 M3.2.1

Edit
Help
Add to favorites
Rem Control Place
STOP READY I/O
ID: M3.2.1

Rem Control Place
STOP READY I/O
M3.2.1
I/O Control
FieldbusCTRL

Start/Stop Setup
Rem Control Place
I/O Control
KeypadStopButton
Yes
Start Function
Ramping
STOP READY I/O
ID:172 M3.2.1

Rem Control Place
STOP READY I/O
M3.2.1
I/O Control
FieldbusCTRL
OK OK
OK
BACK
RESET
OR:
9160.emf
9257.emf
OK
9256.emf
...
OK
Symbol for checkbox selection