Vacon 100X series - Sleep Function

vacon • 145 Parameters
6
6.2.18 Sleep Function
P3.13.5.1 S
LEEP FREQUENCY LIMIT 1
P3.13.5.2 SP 1 S
LEEP DELAY
P3.13.5.3 SP 1 WAKEUPLEVEL
This function will put the drive into sleep mode if the frequency stays below the sleep limit for
a longer time than that set with the Sleep Delay (P3.13.5.2). This means that the start command
remains on, but the run request is turned off. When the actual value goes below, or above, the
wake-up level depending on the set acting mode the drive will activate the run request again if
the start command is still on.
Figure 52. Sleep limit, Sleep delay, Wake-up level
9098.emf
Actual value
Wake-up level
(ID1018)
Frequency
Sleep limit
(ID1016)
Sleep delay
(ID1017)
SleepRegulating mode Regulating mode