Vacon 100X series - Quick Setup; Monitor

4
vacon • 37 User Interfaces
4.3.1 Quick setup
In the Quick Setup parameter group you will find the different wizards of the Vacon 100 X Solar
Pump Application. More detailed information on the parameters of this group you will find in
chapter 3.
4.3.2 Monitor
Multi-monitor
NOTE: This menu is not available in text keypad.
On the multi-monitor page, you can collect four to nine values that you wish to monitor.
Figure 14. Multi-monitoring page
Change the monitored value by activating the value cell (with arrow buttons left/right) and
clicking OK. Then choose a new item on the Monitoring values list and click OK again. More de-
tailed information on the monitor items can be found in chapter 5.
Trend curve
The
Trend Curve feature is a graphical presentation of two monitor values at a time.
Basic
The basic monitoring values are the actual values of selected parameters and signals as well
as statuses and measurements.
I/O
Statuses and levels of various input and output signal values can be monitored here.
Extras/Advanced
Monitoring of different advanced values, e.g. fieldbus values.
Timer functions
Monitoring of timer functions and the Real Time Clock.
PID Controller
Monitoring of PID controller values.
Main Menu

Quick Setup
( 17 )

Parameters
( 12 )

ID: M1
STOP READY I/O
( 5 )
Monitor




Monitor
Multimonitor
(13)
Basic
(13)
Timer functions
(10)
STOP READY I/O
ID: M2.1
0.0rpm
STOP READY I/O
Multimonitor
0.00 Hz
ID25 FreqReference
Output Freq
0.00Hz
Motor Curre
0.00A
Motor Torque
0.00%
Motor Voltage
Motor Speed
Motor TemperaUnit TemperaDC-link volt
20.0 Hz
FreqReferenc
0.0V
0.0V 81.9°C 0.0%
ID:1 M2.1.1.1
STOP Ready I/O
FreqReference
Output frequency
Motor Power
FreqReference
Motor Speed
Motor Current
Motor Torque
0.00 Hz
10.00 Hz
0.00 rpm
0.00 A
0.00 %
0.00 %
OK OK
OKOK
9171.emf