Valtra 900 - J 7.4. Power Take

J. Specifications
---103---
J 7.4. Power take---off
2 Nominal PTO speeds r/min 540/1000 r/min or 540/540E (750) r/min. . . . . . . . . . . . . . . . . . . . . . .
Engine speeds in different PTO alternatives
Engine speed at PTO speed
PTO speeds 540 540E (750) 1000
540 + 540E 1890 1594 (2214) ---
540 + 1000 1890 --- 2074
PTO shaft ISO 500---1979 Z6 ø35 mm. . . . . . . . . . . . . . . . . . . . . . . .
Control mechanically by a lever between 2 PTO speeds, different clutch. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
which is controlled by a separate lever
Lower link end distance from PTO shaft
(T---measure, mm)
The len
g
th of the lower
PTO shaft
T
h
e
l
e
n
g
t
h
o
f
t
h
e
l
o
w
e
r
links (mm)
6---splines
900 652
980 732
J 7.4.1. Running speed at different nominal revs of the rear PTO (km/h)
There are speed tables only for small, medium and large tyres/tires, the dynamic rolling radius is in brackets. The values
for other tyres/tires can be found by comparing with those in the table.
1. Forward/reverse models
16.9---30, 16.9R30, 480/70R30
(dynamic rolling radius R =
695 mm)
13.6---38, 13.6R38
(dynamic rolling radius R = 740
mm)
r/min 540E 540 1000 r/min 540E 540 1000 r/min
r/min 1594 1890 2074 r/min 1594 1890 2074 r/min
LL1 0.6 0.7 0.8 LL1 0.6 0.7 0.8 LL1
LL2 0.9 1.0 1.1 LL2 0.9 1.1 1.2 LL2
LL3 1.3 1.5 1.6 LL3 1.3 1.6 1.7 LL3
LL4 1.8 2.1 2.3 LL4 1.9 2.2 2.5 LL4
M1 2.3 2.7 3.0 M1 2.5 2.9 3.2 M1
M2 3.4 4.1 4.5 M2 3.6 4.3 4.7 M2
M3 5.0 5.9 6.5 M3 5.3 6.3 6.9 M3
M4 7.1 8.4 9.2 M4 7.5 8.9 9.8 M4
H1 8.0 9.5 10.4 H1 8.5 10.1 11.1 H1
H2 11.8 14.0 15.4 H2 12.6 14.9 16.4 H2
H3 17.3 20.5 22.5 H3 18.4 21.8 23.9 H3
H4 24.5 29.1 31.9 H4 26.1 30.9 34.0 H4
69j---2
Cat 2