Valtra 900 - D 2.4.3. Other Controls

---43---
D. Instruments and controls
D 2.4.2.5. Switch for rear working lights (2.5)
2.8
2.7
2.6
2.5
69---31,4
The parking lights or full/dipped---beam headlights must
be switched on when using the working lights.
D 2.4.2.6. Switch for rotating warning light (2.6)
(extra equipment)
D 2.4.2.7. Control stop switch (2.7) (extra equip-
ment)
The operating instructions for the control stop switch are
under “Extra equipment” (in section K) on page 115.
D 2.4.2.8. Electric main circuit switch (2.8) (extra
equipment)
The operating instructions for the electric main circuit
switch are under “Extra equipment” (in section K) on
page 115.
D 2.4.3. Other controls (3)
D 2.4.3.1. 3---pin power socket (3.1)
2
1
3.1
69---31,5
The socket (3.1) is of the 3 pin, type ISO/TR 12369.
Current (DC) can be taken for various devices, (1) 5A
through the ignition switch, and 25A (2) from the battery,
for use by the implement(s) etc. The male connector part
number is 33615500.
D 2.4.3.2. Lighter (3.2)
3.2
3.3
3.4
69---31,6
Extra equipment, also for mechanical linkage model.
D 2.4.3.3. Switch for front PTO (3.3) (extra equip-
ment)
The operating instructions for the front power take---off are
under “Extra equipment” (in section K) on page 116.
D 2.4.3.4. Switch for rear fog light (3.4) (extra equip-
ment)
Standard in some marketing areas.