Valtra 900 - Specifications; K 2.8.4. Front Linkage; Instructions for Operating

---132---
K. Extra equipment
3.2. Grease regularly:
--- nipple (4), use Valtra Calsium LF --- Grease. After
greasing turn the jaw from left to right at least 90q, this
will ensure the grease spreads evenly over the desired
surfaces.
NOTE: If the jaw is rusted e.g. due the fertiliser, do not
use a rust ---loosening agent for removing the rust, take
to an authorized Valtra workshop.
3.3. Grease if necessary or every 1000 hours:
--- nipple (5), use Valtra Calsium LF --- Grease
4. Specifications
--- Max permissible total weight for the tractor is 55 kN
(5500 kg) with all jaws
--- Max permissible vertical loading, for the trailer hitch 12,5
kN (1250 kg) with all jaws
--- Automatic drawbar, main pin diameter 31 mm, 38 mm
--- Mechanical drawbar, main pin diameter 31,5 mm or
model Italy 28 mm, 43 mm, 50 mm
K 2.8.4. Front linkage
1. Instructions for operating
69---103
The control valve is the third valve in the auxiliary
hydraulics valve set (as seen from the drivers seat).
The front linkage rises when the lever is pulled backwards
and lowers when pushed forwards. When pushing the
lever further forwards, it will be in the locked floating
position, then machine will then follow the contour of the
ground.