Occupational safety, fire protection and environmental impacts
VF1807090083 EN revision 15
2.1.3 Qualification requirements of the staff
The instrument may only be installed by a person familiar with the operational, safety and any
other regulations relating to work safety, in force in the place of location of the instrument or
otherwise associated with the place of work. Electric systems may only be installed and
connected by a person qualified in compliance with the applicable legislation of the country of
operation of the instrument.
The instrument may only be opened, set up and adjusted by persons who are physically and
mentally fit, older than 18 years of age, demonstrably trained by their parent organization
in the respective work and familiar with the Instructions for Use, which must be kept in an
accessible place.
2.1.4 Conditions for the safe operation of electrical equipment
Keep the safety labels, symbols and notices legible on the equipment.
Follow the relevant regulations for health and safety at work and the valid local standards laying
down the conditions for the electrical connections of electrical equipment and for their reliable and
safe operation.
Installation, operation and maintenance may only be provided by persons qualified for such
activities in compliance with the valid legislation of the country of operation of the instrument.
Perform inspections of electrical equipment on a regular basis, as required by the internal rules of
the organization or by applicable standards or guidelines of the manufacturer. Inspections may only
be performed by persons qualified for such activities in compliance with the legislation of the
country of operation of the instrument.
All activities related to the electrical equipment must be performed in compliance with
the Instructions for Use.
Any interventions in the design of the device ARE NOT ALLOWED.
Maintenance, cleaning and repair of the device can only be carried out with the power supply
disconnected and technological equipment switched off.
If you detect a failure or damage that you consider a threat to health and safety at work, do not
use the instrument and report the failure to the operator immediately.
The Instructions for Use must always be available for all persons performing activities
associated with the installation, operation and maintenance of the electrical equipment.
ATTENTION, electrical device, do not extinguish with water or foam extinguishers.
The instrument and its operation do not increase fire risk.
2.3. Environmental impact statement
The instrument as such and its operation do not cause any environmental load.
To Next Page
Loading...