Table of Contents
VF1807090083 EN revision 4
5.4.
Storage 32
5.5.
Installation 32
5.6.
Operation verification 34
5.6.1
Instrument actuation ......................................................................................................... 34
5.6.2
Version with an identification card reader ........................................................................... 35
5.6.3
Turning off ....................................................................................................................... 35
5.6.4
Power failure .................................................................................................................... 35
5.6.5
Calibration of the PLC screen ............................................................................................. 36
5.6.6
Initial instrument settings .................................................................................................. 36
6.Instructions for use ......................................................................................... 37
6.1.
Visual and acoustic signalization 37
6.2.
Control elements 38
6.3.
Basic screen 38
6.4.
Contamination measurement procedure 39
6.4.1
Contamination detection by frisker ..................................................................................... 42
6.4.2
Display of measurement results ......................................................................................... 43
6.5.
Service menu 44
6.5.1
Export archive, Export errors ............................................................................................. 46
6.5.2
Clear archive, clear archive of error .................................................................................... 48
6.5.3
Configuration export.......................................................................................................... 49
6.5.4
Configuration import ......................................................................................................... 50
6.5.5
Date and time ................................................................................................................... 51
6.5.6
Ethernet setup .................................................................................................................. 52
6.5.7
Detectors status ................................................................................................................ 52
6.5.8
Detectors response ........................................................................................................... 53
6.5.9
Reset ............................................................................................................................... 54
7.Instrument settings ......................................................................................... 55
7.1.
Setting the measurement parameters by means of the VF-Setup service software 55
7.2.
Setting the measurement parameters by means of web interface 56
7.2.1
Instrument settings ........................................................................................................... 58
7.2.2
Detectors settings ............................................................................................................. 60
8.Maintenance and care of the instrument ........................................................ 62
8.1.
Daily maintenance 62
8.2.
Quarterly maintenance 62
8.3.
Annual and multi-annual maintenance 62
8.4.
Protective foils of foot detectors 63
8.5.
Cleaning the dirt tray for hand detectors 64
8.6.
Checking the switches for foot detector grates 66
To Next Page
Loading...