Table of Contents
VF1807090083 EN revision 3
Table of Contents
Table of Contents .................................................................................................. 3
List of Figures ....................................................................................................... 6
List of Tables ......................................................................................................... 8
Foreword ............................................................................................................... 9
1.Introduction ..................................................................................................... 10
1.1.
Instrument specifications 10
1.2.
Abbreviations 10
1.3.
Terms and definitions 11
1.4.
Acts, regulations and standards 13
2.Occupational safety, fire protection and environmental impacts ................... 14
2.1.
Occupational safety 14
2.1.1
Safety signs used in VF, a.s. and their meanings ................................................................. 14
2.1.2
Obligations of the operator ................................................................................................ 14
2.1.3
Qualification requirements of the staff ................................................................................ 15
2.1.4
Conditions for the safe operation of electrical equipment ..................................................... 15
2.2.
Fire protection 15
2.3.
Environmental impact statement 15
2.4.
Instrument disposal 16
3.Technical specification .................................................................................... 17
3.1.
Surface Contamination Detector SCD-286 18
3.2.
Surface Contamination Detector SCD-525 20
3.3.
Smart Frisking Probe SFP-100 22
4.General description .......................................................................................... 25
4.1.
Purpose of the instrument 25
4.2.
Description of instrument 25
4.3.
Design overview 27
4.3.1
Connectors, description and location .................................................................................. 30
5.Before putting the instrument into operation ................................................. 31
5.1.
Transportation 31
5.2.
Initial preparation 31
5.3.
Power supply 31
To Next Page
Loading...